1. Before using the laser cutting machine, first turn on the water pump to fill the laser tube with water, and check the water circulation frequently during the operation of the machine to ensure that the water circulation in the laser tube is normal and unobstructed.
2. The laser generated in the laser tube is hot and scorching. Please pay attention to the optical path of the laser during operation to avoid being burned by the laser. Remember not to place the skin under the laser head during operation.
3. When the laser cutting machine is working, especially when cutting, please pay attention to the interference of surrounding electronic equipment, and do not place mobile phones and other communication equipment close to the machine.
4. It is strictly forbidden to run the laser cutting machine at full power for a long time, and the maximum cutting power is set to 95%.
5. It is strictly forbidden to place flammable and explosive items near the laser cutting machine to prevent fire.
6. It is strictly forbidden to place any irrelevant total reflection or diffuse reflection objects in the equipment to prevent the laser from directly reflecting on the human body or flammable items.
7. Because there are lasers and high-voltage parts in the machine, non-professionals are strictly prohibited from disassembling the machine without authorization.
8. If the machine fails or a fire occurs, please cut off the power supply immediately.
9. During the operation of the machine, the operator must observe the working condition of the machine at any time and is strictly prohibited from leaving.
10. Follow the machine's switch sequence: turn on the water cooler first, then the air pump power switch, then the workbench panel switch, and finally the laser switch.
11. When processing workpieces, the exhaust and blowing equipment must be turned on.
12. For materials that have not been seen before, the principle of power from low to high should be followed.
13. When changing water, use a clean water pipe or basin, and never use an oily basin to avoid the inner wall of the laser tube from being accidentally sticky and dirty, which seriously affects the life of the laser tube.